D-Link DXS-1100 series User Manual - page 84
D-Link 10 Gigabit Ethernet Switch User Manual
7
7
7
7
Figure 4.107 – L2 Features > LLDP > LLDP Port Settings
The fields that can be configured are described below:
From Port / To Port: Select the appropriate port range used for the configuration here.
Subtype: Select the subtype of LLDP TLV(s). Options to choose from are MAC Address and Local.
Admin State: Select the local LLDP agent and allow it to send and receive LLDP frames on the port.
Options to choose from are TX, RX, TX and RX, and Disabled.
TX - The local LLDP agent can only transmit LLDP frames.
RX - The local LLDP agent can only receive LLDP frames.
TX and RX - The local LLDP agent can both transmit and receive LLDP frames. This is the default
value.
Disabled - The local LLDP agent can neither transmit nor receive LLDP frames.
IP Subtype: Select the type of the IP address information to be sent. Options to choose from are Default,
IPv4 and IPv6.
Action: Enable or disable the action field.
Address: Enter the IPv4 or IPv6 address that will be sent.
Click Apply to accept the changes made.
NOTE: The IPv4 or IPv6 address entered here
should be an existing LLDP management IP
address.
L2 Features > LLDP > LLDP Management Address List
This window is used to view the LLDP management address list.
Figure 4.108 – L2 Features > LLDP > LLDP Management Address List