Leaf Aptus-II Installation Manual - page 28
Mamiya 645 AFD
21
Connecting the Cables
Connecting the Flash Sync Cable
If you want to use flash or strobe lighting, connect the Flash Sync cable to
the Flash Sync socket of the Mamiya 645 AFD camera.
Figure 18: Connecting the Flash Sync cable to the Mamiya 645 AFD camera
Connecting the FireWire Cable
For information about connecting the FireWire cable, see Working in
Tethered Mode, page 65.
Removing the Leaf Digital Camera Back from the Camera Body
1. Place the camera on a steady, flat surface.
2. Turn the camera off.
3. Disconnect the FireWire cable.
4. Slide and push the Release button.
Figure 19: Removing the Leaf Aptus
II digital camera back from a Mamiya 645
AFD camera
5. Tilt the camera back away from the camera body to remove it.
Release Button
Flash Sync
Socket
Flash Sync
Cable