Leaf Aptus-II Installation Manual - page 69
62 Quick
Installation
Reference
5. Connect one end of the Rollei-Aptus II Lens Control interface cable
to the B port of the Rollei Lens Control and the other end to the
Camera Control jack of Leaf Aptus
II.
6. Insert one end of the Camera-to-Sync cable into the Rollei Lens
Control Sync jack and the other end into the Camera-to-Back Sync
jack on Leaf Aptus
II. If you are working in tethered mode, go to step
8 now.
7. Install the compact flash card and power up.
Working in tethered mode:
8. Install the Leaf Capture application from the CD.
9. Start the Leaf Capture application.
10. Connect the FireWire cable between the computer and Leaf Aptus
II.
11. After you connect the cable, the application automatically connects
to Leaf Aptus
II. When the connection is established, the LED
indicator on the digital camera back turns from orange to green.
Note: If you want to work with an external flash, connect the Flash Sync
cable between the Leaf Aptus
II digital camera back and the flash or strobe
unit.
For information about connecting the FireWire cable, see Working in
Tethered Mode, page 65.
Figure 59: Connecting the Leaf Aptus
II digital camera back to a large format
camera and Schneider Shutter Control
A
Lens Control to
Camera Control
C
Lens Control to
Electronic Shutter
A
C