Leaf Aptus-II Installation Manual - page 47
40 Installation
Procedures
Installation Procedures
The procedures in this section together constitute the basic installation
process.
Installing the Focusing Screen
The focusing screen enables you to view the exact area that the Leaf Aptus
,,
digital camera back captures. Before you can install the supplied focusing
screen, you must remove the camera’s original focusing screen.
To remove the original focusing screen:
1. Remove the Contax viewfinder.
2. Pick up the screen frame claw with your finger tip, and pull it gently
upwards to remove the focusing screen.
To install the supplied focusing screen:
1. Insert the edge of the focusing screen underneath the screen pressing
spring.
Figure 37: Installing the focusing screen
2. Press the focusing screen down gently, until it locks into place with a
click.
Important! Do not press or bend the screen pressing spring directly, it may
damage the camera.
Never touch the surface of the focusing screen. If there is dust on the
screen, use a blower or soft lens brush to remove it.
Store unused focusing screens in the screen case according to the
instructions on the case.