Leaf Aptus-II Installation Manual - page 43
Other manuals for Aptus-II:
User Manual, User Manual
of
80
36
Installing the Focusing Screen
Figure 33: Connecting a Camera Control cable to a Hasselblad 503CW camera
Connecting the FireWire Cable
For information about connecting the FireWire cable, see Working in
Tethered Mode, page 65.
Removing the Leaf Digital Camera Back from the Camera Body
1. Place the camera on a steady, flat surface.
2. If any of the following cables are connected, disconnect them:
• FireWire
cable
• Camera-to-Back
Sync
cable
• Flash
Sync
cable
3. Slide the Release button to the right side.
Figure 34: Removing the Leaf Aptus
II digital camera back from a Hasselblad
camera
4. Tilt the camera back away from the camera body to remove it.
Release Button