Leaf Aptus-II Installation Manual - page 59
52 Before
Getting
Started
Before Getting Started
This chapter describes the Leaf Aptus
II digital camera back installation for
the Mamiya RZ67, Mamiya RZ67ProII, and Mamiya RZ67 ProIID cameras.
Items Required for the Installation
For a detailed list of the items required for installation, see Items Required
for the Installation, page 4. In addition to the items shown, your kit will
include the Mamiya RZ67 adaptor plate. You will need the adaptor plate for
the installation procedure.
Important! To avoid installation and operation problems, use only the
accessories supplied in the Leaf digital camera back kit.
Quick Installation Reference
1. Install the focusing screen mask into the viewfinder.
2.
Mount the adaptor plate on the camera body.
3. Remove the protective cover from the Leaf Aptus
II digital camera
back.
4. Attach the digital camera back to the adaptor plate.
5. Connect the Camera-to-Back Sync cable between the camera lens
and Leaf Aptus
II
. I
f you are working in tethered mode, go straight to
step 7.
6. Install the compact flash card. The installation is complete.
Working in tethered mode:
7. Install the Leaf Capture
application from the CD and start the
application.
8. Connect the FireWire cable between the computer and Leaf Aptus
II.
After you connect the cable, the application automatically connects
to the digital camera back. When the connection is established, the
LED indicator on the digital camera back turns from orange to green.
Note: If you want to work with an external flash or strobe, connect the Flash
Sync cable between the Leaf Aptus
II digital camera back and the flash or
strobe unit.
Note: To trigger the camera from the computer, connect the Camera Control
cable (not supplied with the camera back) between the camera body and
Leaf Aptus
II.