Leaf Aptus-II Installation Manual - page 62
Mamiya RZ67/RZ67ProII/ RZ67ProIID
55
Attaching the Leaf Digital Camera Back to the Camera Body
1. Mount the Mamiya RZ67, Mamiya RZ67 Pro II, or Mamiya RZ67 Pro
IID camera on a tripod.
2. Insert the four studs on the Mamiya camera body into the four holes
on the adaptor.
Figure 52: Connecting the Leaf Aptus
II digital camera back
3. Secure the adaptor plate to the camera body by flipping the locking
lever from right to left into the locked position.
4. Remove the protective cover from Leaf Aptus
II.
5. Connect the digital camera back to the camera body. Rest the digital
camera back on the lower supports making sure that the lugs are
properly engaged in the recesses.
6. Move the camera back toward the camera body and check that the
camera’s upper support hooks fit into the slots on the camera back,
and lock it into place.
7. Lock the digital camera back into place.
Figure 53: Locking the Leaf Aptus
II digital camera back into position
Note: Make sure the Multiple/Revolving lever is set to M.
Multiple Revolving lever