Leaf Aptus-II Installation Manual - page 73
70 Connecting
the
FireWire
Cable
Connecting the FireWire Cable
Important: The information in this chapter is relevant to all cameras in this
installation guide. Follow the specific installation procedures for the camera
you are using. It is important that you connect the FireWire cable correctly in
order not to cause unnecessary damage.
Important: To avoid connection problems, use only the Leaf FireWire cable
and repeater supplied with Leaf Aptus
II.
The FireWire cable (IEEE 1394A) links the computer to Leaf Aptus
II. The
cable carries both communication signals and electrical power. The cable is
a hot-plug cable that can be connected or disconnected without turning the
computer off or quitting the application.
1. Connect one end of the FireWire cable to the port at the bottom of
/HDIAptusII. Make sure that the
FireWire cable connector is aligned to the
left of Leaf Aptus
II.
Figure 61: Connecting the FireWire cable to the Leaf Aptus
II digital camera back
2.
Connect the other end of the cable to the port on the computer.
Tip: When you connect the FireWire cable after you start the Leaf Capture
application, the application automatically connects to the Leaf Aptus
II digital
camera back and recognizes the connected camera type.