NEC Univerge SV8100 User Manual - Key
18
Terminal Setup With the Feature
Key
Microphone On/Off
LED on Mic key shows the status of the built-in
microphone.
STEP 1: Press Feature and 1.
To Select Ringer Tone
DT Series has 8 kinds of ringer tones that you can
select.
To Change your Extension Incoming Ring Tone
STEP 1: Press Speaker and dial 720.
STEP 2: Dial 1 to set Intercom ring; Dial 2 to set Trunk
ring.
STEP 3: Dial code for the desired ring pattern (1~8).
Display below shows when INT is selected.
STEP 4: Press Speaker to hang up.
To listen to the Incoming ring choices:
STEP 1: Press Speaker and Dial 711.
STEP 2: Dial 1 to listen to Intercom ring; Dial 2 to listen
to Trunk ring.
STEP 3: For Intercom Ring:
Dial the code for the ring pattern you want to
hear (1-8).
1: INT 2: EXT
SET INCOM RING
INCOM RING 1-8:?
SET INT INCOM RING
TONE No.
Tone Range
1
High
2
Mid Range
3
Low
4
Ring Tone 1
5
Ring Tone 2
6
Ring Tone 3
7
Ring Tone 4
8
Ring Tone 5