Oce Arizona 500 User Manual - page 110
Océ | Error Messages and Troubleshooting
6-4
WARNING
no media
If no media is loaded, reload the media. If
media is loaded, perform the media installa-
tion procedure again.
WARNING
take-up roll full
The take-up roll has reached maximum
diameter. Remove the roll, and install a new
empty core.
Close All Doors and
press ACCEPT button
Door is open. Close all doors, and press the
ACCEPT button.
Waste Bottle Almost Full
Press ACCEPT to Continue
Ink waste container is almost full. Monitor
closely, and replace or empty the ink waste
container. Then, press ACCEPT.
Please Replace Waste Bottle
and press ACCEPT button
Ink waste container is full. Replace or empty
the ink waste container, and press ACCEPT.
Media Encoder error
press ACCEPT button
The media is not contacting the media
encoder wheel properly. Perform the follow-
ing steps before you press ACCEPT:
1. Lower the media-encoder pinch roller.
2. Verify the supply and take-up core
notches are engaged into the mandrel hubs.
3. Verify that the media is not too thick or
stiff.
BLOTTING CLOTH IS ALMOST OUT
press ACCEPT to continue
Check the amount of blotting cloth available
and monitor frequently. Replace the blotting
cloth before the next long print job.
BLOTTING CLOTH IS OUT
press ACCEPT to continue
Replace the blotting cloth, then press
ACCEPT.
Status and Low Ink Messages IR/PZ
XX:XX Media: XXX' Used: YY’ IR/PZ:
Idle
Printer is idle. Printer feedback and status
for the operator.
XX:XX Media: XXX' Used: YY’ IR/PZ:
DOOR OPEN
Printer is idle, but the door is open. Close
the door to return to idle.
XX:XX Media: XXX' Used: YY IR/PZ:
CANCELLING PRINT
Printer is cancelling print. Provides printer
feedback and status for the operator.
CONTROL PANEL MESSAGE
EXPLANATION AND ACTION