Oce Arizona 500 User Manual - page 144

Océ

C-6 

U. At the end of the print, place a small flag at the 

edge of the print. Make sure it extends out from 

the side of the media and is secure. This will 

identify the beginning of the second side of the 

print. 

- see Figure C.

V. When all “Side One” jobs are completed, 

advance approximately 10 feet of media prior to 

cutting the substrate. This will allow for an 

ample leader to leader to load the media on the 

second side and area to perform maintenance, if 

necessary.

Figure C

Step 3: Preparing for two-sided printing

W. Remove the roll of printed media from the front of the printer and use it as the “new” 

supply roll.

X. Select 

Load Media 

from the 

Océ

 Arizona 500 control panel.

Y. When prompted, specify 

Second-Side 

in the control panel, and complete loading the 

substrate.

Z. Send the job to be printed to the 

Océ

 Arizona 500.

AA. Prior beginning the second side of the print job, the 

Océ

 Arizona 500 control panel will 

prompt you to adjust the second side media into position.

BB. Press 

Accept 

and using the 

+\- 

keys, align the Print Point mark you made on the media 

with the mark on the platen from step #1 J above. Remove the flag from side 1. When done 

press 

Accept 

and the printer will begin the printing process for the second side of the print. 

- see Figures D and E.

Note:

Be aware of the 

Space Between Print 

setting as this will affect how much leeway 

you have to line up prints on the second side.

Note:

Providing a minimum of 1 inch bleed on each side will help ensure usability of 

both sides of the output.