Oce Arizona 500 User Manual - page 52

Océ | Media System 

3-26 

The feed adjustment feature enables the adjustment of media stepping to 

compensate for variation in media lots and environmental factors. The plus 

direction lengthens each media step. The minus direction shortens each media step.

For additional information, see “Firmware 2.2 Notes” on page C-121.

9.

Press ACCEPT. You then see:

WRITING GAP

“Other” head gap: optimal/wide

Use the +/- buttons to set optimal or wide. The default is optimal. This option is 

only selectable during the Load Media process.

The writing gap wide feature sets the print carriage at its maximum height to 

accommodate media that may have surface wrinkles. They can lead to carriage 

strikes, which may result in a ruined print and/or potential print-head damage.

For additional information, see “Firmware 2.2 Notes” on page C-12.

10.

Press ACCEPT. You then see:

Sizing media

please wai

t

The printer sizes the media. If an error occurs, check the alignments along the 

media path from the supply to the take-up core.

If no error occurs, you then see:

MEDIA MENU

media delivery mode: roll to roll or Print & Go

Use the +/- buttons to select Print & Go.

11.

Press ACCEPT. You then see:

Stabilizing media

please wait

When stabilizing is complete, printer status information is displayed.

3.4.3

EMTU Take-up Roll Reattachment

Follow these steps to remove a full/partial take-up roll and reattach media to a new empty 

take-up core:

1.

Press the ADVANCE MEDIA button once, and press the + button until at least one 

foot of media is exposed through the paper-feed access door after the media is cut.

2.

Press the CANCEL button to ensure the media does not rewind at step 4.

3.

Cut the media so that at least one foot of media is exposed through the paper-feed 

access door, and remove the full/partial take-up roll.