Oce Arizona 500 User Manual - page 37

Roll-to-Roll Media Installation 

7/26/04

3-11

17.

Press ACCEPT. You then see:

MEDIA MENU

conserve media: ON

Use the +/- buttons to turn media conservation ON/OFF. The default value is ON.

When set to ON, the printer rewinds the substrate to minimize waste before 

printing the next image.

When set to OFF, the printer does not rewind the substrate before printing. This 

setting should be used for media that is very thin or adhesive backed, which may 

wrinkle during rewinding or become malformed by the heat required to dry the 

inks.

For additional information, see “Firmware 2.2 Notes” on page C-12.

18.

Press ACCEPT. You then see:

MEDIA MENU

feed adjustment: +/- 0 - 10

Use the +/- buttons to set the feed adjustment from -10 to +10. The default value 

is 0.

This feature enables the adjustment of media stepping to compensate for variation 

in media lots and environmental factors. The plus direction lengthens each media 

step. The minus direction shortens each media step.

For additional information, see “Firmware 2.2 Notes” on page C-12.

19.

Press ACCEPT. You then see:

Sizing media

please wai

t

The printer sizes the media. If an error occurs, check the alignments along the 

media path from the supply to the take-up core.

If no error occurs, you then see:

Stabilizing media

please wait

When stabilizing is complete, printer status information is displayed.

Media Types: Other

Selecting Other enables additional menus for manual media setup. When changing values, 

holding the +/- buttons continuously increments or decrements the value repeatedly. Follow 

the steps below for this media type option:

1.

You then see:

MEDIA MENU 

Other