Oce Arizona 500 User Manual - page 76

Océ | Control Panel

4-22 

2.

Press the ACCEPT button. You then see:

OPERATOR 

print parameters

3.

Press the MENU button four times. You then see: 

OPERATOR 

media menu

4.

Press ACCEPT. You then see: 

MEDIA MENU 

Media table version: XXX

The media table contains the printer set-up values that are implemented when a 

media is selected through the Media Type submenu. The version is updated by a 

separate file that typically accompanies a new firmware version.

5.

Press ACCEPT. You then see: 

MEDIA MENU

print side: first side

If you select the first side, go to step 9.

6.

Use the +/- buttons to select the second side. You then see:

MEDIA MENU

print side: second side

7.

Press ACCEPT. You then see:

SECOND SIDE

supply core OD: (3.10” - 4.0”)

Use the +/- buttons to enter the correct core diameter. The value is increased or 

decreased in .01-inch increments. If you do not know the diameter, use a ruler and 

measure the outside diameter of the core, and enter the value in this submenu.

8.

Press ACCEPT. You then see:

SECOND SIDE

condition media: OFF

Use the +/- buttons to turn media conditioning OFF/ON. The default value is 

OFF. 

Condition Media assists in accurate two-sided printing where the printed media 

surface tension of the first side affects the printing of the second side. When set 

ON, the printer advances the media the length of the print and rewinds to the 

starting point.

For additional information, see “Firmware 2.2 Notes” on page C-12.