Oce Arizona 500 User Manual - page 61
Operator
7/26/04
4-7
Use the +/- buttons to select the required horizontal margin value for a job.
4.
Press ACCEPT. You then see:
PRINT PARAMETERS
ver margins: (0.2" - 4.0")
Use the +/- buttons to select the required vertical margin value for a job.
5.
Press ACCEPT. You then see:
PRINT PARAMETERS
Statistics Menu: (on or off)
When the statistics menu is set to On, the printer prints a set of job statistics in the
white space below the print area. Use the +/- buttons to turn statistics On or Off.
6.
Press ACCEPT. You then see:
PRINT PARAMETERS
stripe: SINGLE
Use the +/- buttons to change the stripe setting to DUAL. The default setting is
SINGLE.
The available print width is reduced with dual spit stripes. A job ripped and printed
with a single stripe may generate a
media too narrow
error when a reprint is
selected with dual stripes.
For additional information, see “Firmware 2.1 Notes” on page C-2.
7.
Press ACCEPT. You then see:
PRINT PARAMETERS
quad strike: OFF
Use the +/- buttons to change the quad strike setting to ON. The default setting is
OFF.
When the quad strike option is enabled (On), heavier ink coverage is supplied by
the printer. This increased coverage is required by some media. This function is
only available during 8-pass printing for selective double-strike image files that have
been processed through PosterShop. When enabled, the “[Quad Strike: ON]”
message is included in the print statistics line.
For additional information, see “Firmware 2.1 Notes” on page C-2.
8.
Press ACCEPT. You then see:
PRINT PARAMETERS
minimal maintenance during print: OFF
Use the +/- buttons to change the minimal maintenance during print setting to
ON. The default setting is OFF.