Oce Arizona 500 User Manual - page 143
7/26/04
C-5
G. Observe the 4 marks made by the BLACK heads in the rear right hand corner -
see Figure A.
H. Using the second BLACK mark from the rear of the printer as a guide, and using a
straight edge to ensure accuracy, create a line continuing to the right side of the platen -
see
Figure A
.
I. Using masking tape, affix a piece of tape along this straight line -
see Figure A.
J. Measure 5 mm
from the front edge
of the tape for 8-pass
printing and draw a
straight line to the
edge of the platen. -
see figure B.
K. Measure 10 mm
from the front edge
of the tape for 4-pass
printing and draw a
straight line to the
edge of the platen. -
see figure B
.
L. These lines
accurately reflects
where your
Océ
Arizona 500 begins
Figure B
printing in 8- and
4-pass modes, and will be used to line up the image on the reverse side.
Step 2: Printing the first side of your graphic
M. From the control panel, select
Menu >>> Operator >>> Print Parameters >>>
Statistics
and turn “Statistics”
off
.
N. In Onyx Rip Queue, highlight the
Océ
Arizona 500 and select
Change
.
O. From the
Change Media and Placement
window select
Setup
.
P. From the
Placement Strategy
window, set the
Top
and
Left
offsets to
0.00
and set
Justification
to
Right
.
Q. Open the file to be printed in Pre-Flight.
R. Under
Preview & Size
tab, ensure the
X
and
Y
origins are set for
0
(zero).
S. In the
menu,
Print Setup
window, select the
Marks
tab and check to see that
Label
is
not enabled
.
T. Print the selected job(s). Be sure it is aligned to the right.