Oce Arizona 500 User Manual - page 40
Océ | Media System
3-14
3.3.3
Take-up Roll Reattachment
Follow these steps to remove a full/partial take-up roll and reattach media to a new empty
take-up core:
1.
Press the Load Media button. You then see:
Load Media
new supply roll?
2.
Press the Menu button. You then see:
Load Media
reattach takeup?
3.
Press the ACCEPT button. You then see:
Use +/- keys, attach
takeup, press ACCEPT
The take-up dancer moves automatically up and out of the way.
4.
To unload the full or semi-full roll of images, gently open the front door completely.
5.
Cut the media attached to the take-up roll along the take-up dancer and remove the
take-up mandrel from the printer (see Figure 3-13).
Figure 3-13 Cutting Media Above Take-Up
Note:
Avoid cutting into the black rubber drive roll.