Oce Arizona 500 User Manual - page 75
Operator
7/26/04
4-21
Use the following steps to set the prewarm time:
1.
Navigate to:
MAIN MENU
operator
2.
Press the ACCEPT button. You then see:
OPERATOR
print parameters
3.
Press the MENU button three times. You then see:
OPERATOR
pre warm
4.
Press ACCEPT. You then see:
PRE WARM
pre warmup time: 0 - 150 min
Use the +/- buttons to adjust the prewarm-up time.
5.
Press ACCEPT. You then see:
PRE WARM
ACCEPT to begin
6.
Press ACCEPT. You then see:
WARMING: Pre warmup
You then see:
PREHEAT: Pre warmup
You then see:
HEATING: Pre warmup
0.4.5
Media
The Media menu enables an operator to change the type of media selected during media
load. During media load new supply roll, the
MEDIA MENU media nam
e (see step 9 on
page 4-22) is automatically displayed.
Selecting the Media Type
The label on the end of the supply media box states the media type. Follow these steps to
select the type of media:
1.
Navigate to:
MAIN MENU
operator