Oce Arizona 500 User Manual - page 85
Configure I/0
7/26/04
4-31
9.
Press ACCEPT after changing the minute. You then see:
SET CLOCK
set time
0.5
Configure I/0
The Arizona 500 printer has two types of data ports, Centronics
parallel and low-voltage
differential (LVD) SCSI-2.
0.5.1
Parallel Port Configuration
Follow the steps below to configure the parallel port:
1.
Navigate to:
MAIN MENU
CONFIGURE I/O
2.
Press the ACCEPT button. You then see:
CONFIGURE I/O
active: parallel
If the current setting is SCSI, you will see:
CONFIGURE I/O
active: SCSI
Use the +/- buttons to select parallel. Configuration for SCSI is described below.
3.
Press ACCEPT. You then see:
PARALLEL PORT
SLOW or FAST
Use the +/- buttons to select SLOW or FAST. The default value is FAST.
4.
Press ACCEPT or MENU. You then see:
PARALLEL PORT
timeout XXX seconds
The default value is 60 seconds.
5.
Press ACCEPT or MENU. You then see:
CONFIGURE I/O
active: parallel
Note:
This port is only used by service engineers for downloading firmware.