SAGEMCOM MF 4591 User Manual - page 42
42
Sagemcom · MF 4591
EN
Scanner
Introduction
You can scan a document and save it onto a USB stor-
age medium or on a network computer.
Companion Center
You'll find the software on the supplied installation
CD
Companion Center SFX
. In this way, you can scan
documents from your computer, send faxes, and man-
age the device settings via the web interface (see also
chapter
Installing the Driver and Software
, page 48).
Loading Documents
· Loading Documents
Specifications for Documents
Unsuitable Documents!
1. Insert the documents face down into the docu-
ment feeder. The lower most document will be
fed in first. You can insert up to 30 documents
(80¦g/m²) at a time.
2. Push the document guide inwards, so that it lies
level on the documents.
Scan Document and
Save to a Computer
· Scan Document and Save to a Computer
Introduction
Using this function, scan a document with your de-
vice and transfer it onto a computer which is con-
nected directly to the device using a USB cable.
Start Scanning from Computer
Make Scans Using
Standard Settings
1. Press
SCAN.
2. Select with
[SCANTO PC USB.
3. Confirm with
OK.
4. Press
OK.
Make Scans Using User-
defined Settings
1. Press
SCAN.
2. Select with
[SCANTO PC USB.
3. Confirm with
OK.
4. Select with
[SETTINGS.
5. Confirm with
OK.
9 Scanner
Specifications for Docu-
ments
Width of Documents
140¦–¦218¦mm
Length of Documents
128¦–¦600¦mm
Paper Weight of the
Documents
60¦-¦90¦g/m²
Capacity
30 page (60¦-¦90¦g/m²)
Manufacturer’s Recom-
mendation for Optimum
Operation
A4 · A5 · Letter · Legal
(80¦g/m²
CAUTION!
Unsuitable Documents!
Do not insert any documents into the device
that ...
... are wet, have been edited with correction
fluid, are soiled or have a coated surface.
… that are written on with a soft pencil,
with paint, chalk or charcoal.
… originate from newspapers or magazines
(printing ink).
… that are held together with office or
notebook staples or with tape or glue.
… that are pasted with note papers.
… that are creased, crumpled or torn.
Start Scanning from Computer
Using the
Companion Center SFX
software,
you can call up the scan on the computer. You
can also start the scanning process from any
other graphics program if it is supported by
the Twain Driver. Select the Twain Scanner
Driver as your scanner.
Access Function
You can also call the function by pressing
OK, 31 and OK.
Access Function
You can also call the function by pressing
OK, 31 and OK.