SAGEMCOM MF 4591 User Manual - page 52
52
Sagemcom · MF 4591
EN
Setting Up the
Network (LAN)
· Setting Up the Network (LAN)
Network (LAN)
Introduction
All the required settings such as subnet masks, the
gateway address or the Domain Name Server (DNS)
must match those of the network. You can access
this information in the network configuration of your
computer or router.
Set IP Address
Assignment
Introduction
The IP address assignment allows you to select
whether your device's IP address is assigned dynam-
ically by a DHCP or BOOTP router/server or statically
assigned by the user. You can enter IP addresses,
subnet masks, gateways or two alternative domain
name servers (DNS) for the configuration of the stat-
ic network connection.
1. Press
OK, 071 and OK.
2. Select automatic or manual configuration using
[.
3. Confirm with
OK.
This Process May Take a Few Moments.
Set Static IP Address
Assignment
Available Function (LAN)
Enter IP Address
Introduction
The IP address is the address of the device in the net-
work. It must not match the IP address of the com-
puter or other network components, however it must
be located in the IP field.
1. Press
OK, 0721 and OK.
2. Enter the IP address (for example
192.168.001.×××).
3. Confirm with
OK.
Entering the Subnet Mask
Introduction
In a network with a gateway or router, the subnet
mask indicates whether the respective data packets
are addressed to an internal recipient in the network
or whether they should be sent to a recipient outside
of the network.
1. Press
OK, 0722 and OK.
2. Enter the subnet mask (for example
255.255.255.000).
3. Confirm with
OK.
Enter IP Address of the Access
Point (= Gateway)
1. Press
OK, 0723 and OK.
2. Enter the IP address of the access point (Access
Point, Router).
3. Confirm with
OK.
Enter Domain Name Server
(DNS)
Introduction
The DNS translates IP addresses in the names of in-
ternet pages and vice-a-versa. You can enter a prima-
ry and secondary DNS.
Enter Primary DNS
1. Press
OK, 0724 and OK.
2. Enter the address of the primary DNS.
3. Confirm with
OK.
Enter Secondary DNS
1. Press
OK, 0725 and OK.
2. Enter the address of the secondary DNS.
3. Confirm with
OK.
Verify DHCP Settings
Available Function (LAN)
Introduction
With these functions, you can verify the assigned
network settings from your network's DCHP router.
You cannot modify the settings.
Displaying the IP Address
1. Press
OK, 0731 and OK.
2. The current IP address is displayed; it is the ad-
dress that your device is registered with on the
network.
Display Subnet Mask
1. Press
OK, 0732 and OK.
2. The subnet mask being used is displayed.
Available Function
The network functions are only available
when you select the LAN as the network con-
nection (see also chapter
Setting up a Net-
work Connection
, page 51).
This Process May Take a Few Moments.
The automatic configuration of IP address
and subnet mask on the connected network
PCs may take a moment.
Available Function
This function is only available if you have se-
lected static IP address assignment with the
function
071.
IP-Address
The first three blocks of numbers refer to
the IP field; this information must match
the IP address on your computer. The last
three digits determine are the individual
IP address of the device. You can enter any
number between 000 and 255. However,
this number must be unique within the
network; it may not be used on any other
PC or network component.
Available Function
This function is only available if you have se-
lected automatic IP address assignment with
the function
071.