SAGEMCOM MF 4591 User Manual - page 78
78
Sagemcom · MF 4591
EN
Using Service Codes
· Using Service Codes
Introduction
The service codes delete all the changed settings and
your device is reset to factory settings. It may be pos-
sible that the device with the changed settings reacts
differently than expected.
Using Service Codes
1. Press
OK, 933 and OK.
2. Enter a service code:
70158—Deletes all changed set-
tings. Saved data and telephone book entries re-
main intact.
70026—Deletes saved faxes, when
there are problems with printing.
3. Confirm with
OK.
4. Select with
[YES.
5. Confirm with
OK.
Power Cycling
· Power Cycling
Power Cycling
If a problem occurs that cannot be corrected with the
instructions in this user manual (see also the help
below), follow the steps given here.
1. Switch the device off using the on/off switch on
the rear.
2. Wait at least ten seconds.
3. Switch the device on using the on/off switch on
the rear.
4. Follow the instructions on the display. If the
problem repeats, please contact our technical
customer service or your retailer.
Spaltenumbruch
%%%Spaltenumbruch$$$
CAUTION!
Settings will be Deleted!
Only use the service codes if this is abso-
lutely necessary. Some service codes also
delete saved messages and telephone book
entries.
Cancelling Entry
If you have entered the incorrect code, you
can cancel the entry with
NO.