Tadiran Telecom EMERALD ICE Installation Manual - page 83
Emerald ICE Installation & Hardware Reference Manual
6-5
T1/
P
RI
Ca
rd
Installation
an
d
Setu
p
6
Installation on KSU4
1. Turn off the power on the KSU4 (Expansion) cabinet if it is on.
2. Install the T1/PRI Card on the Base Board of KSU4 (Expansion Cabinet)
using the Standoffs (4) provided.
3. Connect the Connector Cable from T1/PRI Card to the marked Connector
Slot on the T1/PRI Card.
4. Connect an RJ45 or 15‐Pin connector to the T1/PRI Card, based on the
type of connectivity provided by your TELCO.
5. Turn the power on KSU4 to “ON”. When a link is established the follow‐
ing Link Indication LED’s will be illuminated.
6. Proceed with the RMP Programming in the following section.
T1/PRI Card (PRI Shown)
Base Board
KSU4
Connector Cable
Standoffs (4)
Connector Slot
RJ45
15-Pin
Link Indication LED’s
Green