Tadiran Telecom EMERALD ICE Installation Manual - page 87
Emerald ICE Installation & Hardware Reference Manual
6-9
T1/
P
RI
Ca
rd
Installation
an
d
Setu
p
6
d. Enter a value in the Incoming field. This field specifies the digits that
will be received on the Digital Trunk in the CO Route for which the
Translation table is assigned. When digits are received, they will be
compared to this Incoming field. When a match is found, the number
will be translated into the associated Destination Number. 12 digits
(0‐9, X) can be programmed. Default is “Null” for all entries.
e. Enter a value in the Destination (Day) Field . This field specifies the
Number to which the Incoming digits are translated in Day Service
Mode. The Destination Number can be an Extension, Hunt Group,
Operator, System Speed Dial, LCR or Trunk Route Directory Number.
The Destination Number can have a different number of digits than
the Incoming Number entry. 12 digits (0‐9, X) can be programmed.
The Default is Null for all entries.
f.
Enter a value in the Destination (Night) Field. This field is similar to
the Destination (Day), however, it works for Night Service Mode.
When you have completed entering information from steps d, e, and f, click
on the
button to enter your information into the table. Click on the
Update button to enter your settings into the RMP database.
T1 Setup
After completing steps 1 through 7 above, proceed with the following to set up the
RMP for operation with the T1 card.
1. Select RP, CO Line Application, T1 Card as shown below.