Tadiran Telecom EMERALD ICE Installation Manual - page 94
6-16
Emerald ICE Installation & Hardware Reference Manual
T1/
P
RI
Ca
rd
Installation
an
d
Setu
p
6
10. On the keypad of your Deluxe Telephone Set, select 07-05-O3 and then
press the softkey beneath save to display the CHANNEL SETTINGS
display. Press the softkey beneath show to display all of the settings.
There are 24 T1 channels available- each assigned to a Trunk directory.
Each channel must be programmed to designated the type of channel and if
the Loop Back option is available on that channel.
11. At the CHANNEL SETTINGS display enter a channel number and then
press the softkey beneath show to display the settings.
12. At the CHAN. TYPE display continously press the softkey beneath chg
to select a channel type. Available selections are LOOP(Loop Start),
GROUND (Ground Start), DID (Direct In Dial)(Analog), I_E&M (Inter‐
meddiate E&M) or W_E&M (Wink E&M). The default is W_E&M. Press the
softkey beneath next to continue.
Loop Start is similar to Analog Trunk with Loop Start. Ground Startis
similar to Analog Trunk with Ground Start. A “Tip Ground” must be
detected first and then the dialed number would be sent to CO for the
outgoing trunk call.
Press the
v
button when finished.