Vacon 100 INDUSTRIAL Installation And User Manual - Caution!
Safety
vacon • 4
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
1
1.3
Earthing and earth fault protection
The Vacon 100 AC drive must always be earthed with an earthing conductor connected to the
earthing terminal marked with
.
The earth leakage current of Vacon 100 exceeds 3.5mA AC. According to EN61800-5-1, one or
more of the following conditions for the associated protective circuit shall be satisfied:
a)
The protective conductor shall have a cross-sectional area of at least 10 mm2 Cu or 16
mm2 Al, through its total run.
b)
Where the protective conductor has a cross-sectional area of less than 10 mm2 Cu or
16 mm2 Al, a second protective conductor of at least the same cross-sectional area
shall be provided up to a point where the protective conductor has a cross-sectional
area not less than 10 mm2 Cu or 16 mm2 Al.
c)
Automatic disconnection of the supply in case of loss of continuity of the protective
conductor.
The cross-sectional area of every protective earthing conductor which does not form part of
the supply cable or cable enclosure shall, in any case, be not less than:
- 2.5mm
2
if mechanical protection is provided or
- 4mm
2
if mechanical protection is not provided.
The earth fault protection inside the AC drive protects only the drive itself against earth faults
in the motor or the motor cable. It is not intended for personal safety.
Due to the high capacitive currents present in the AC drive, fault current protective switches
may not function properly.
CAUTION!
Do not perform any voltage withstand tests
on any part of Vacon 100. There is a
certain procedure according to which the tests shall be performed. Ignoring this
procedure may result in damaged product.