VoiceGear SkyBridge User Manual - page 51
P a g e
| 51
Copyright ©2008 IndustryDynamics. All Rights Reserved.
7.1 SIP Channel Configuration
SIP channel configuration settings allow you to configure PBX connectivity settings using SIP protocol. VoiceGear
SkyBridge utilizes G.711 A‐law/µ‐law codecs over SIP 2 protocol. To configure SIP integration to your PBX, the
following general approach has to be followed:
1.
Locate SIP channel configuration screen by selecting Channels‐>SIP from the main menu.
2.
Configure basic and advanced SIP settings to values required by your PBX system. Default settings will
work fine with most PBX systems.
3.
Setup a SIP trunk by clicking the “Create SIP trunk” button and point it to the IP or a fully qualified domain
name of your PBX system.
4.
Create a SIP trunk on your PBX and point it to the IP or a fully qualified domain name of the VoiceGear
SkyBridge gateway.
5.
Create incoming and outgoing routes to be able to access the newly created VoiceGear SkyBridge trunk.
Please Note:
Please consult your PBX user manual for more information on how to perform the PBX-side setup. In most
cases, configuring a PBX system to work with VoiceGear SkyBridge via SIP is the same as configuring it to
work with an external SIP provider.
7.1.1 Basic SIP Settings
Basic SIP settings allow you to configure basic parameters applicable to the SIP server component running on
the VoiceGear SkyBridge gateway.
Image 41: SIP server settings
For more details on basic SIP settings please refer to the table below.