VoiceGear SkyBridge User Manual - page 55
P a g e
| 55
Copyright ©2008 IndustryDynamics. All Rights Reserved.
Remote Side IP
An IP or a fully qualified domain name of the PBX system required for trusted
authentication.
Remote Side Port
A network port (UDP) the PBX system uses to listen for incoming calls.
DTMF Mode
This setting specifies the method of passing DTMF tones (touch tone key presses) from
the PBX to the VoiceGear SkyBridge gateway. Available modes include INFO and RFC2833
and must match DTMF mode configured on the remote PBX side.
Connection Enabled
Specifies if the trunk is active.
7.1.3.2 Advanced SIP Trunk Settings
Advanced SIP trunk settings are used to fine tune PBX connectivity and in most cases do not need to be changed.
Image 45: Advanced SIP trunk configuration settings