VoiceGear SkyBridge User Manual - page 65
P a g e
| 65
Copyright ©2008 IndustryDynamics. All Rights Reserved.
inward dialing” and the extension has a DID number assigned. The Destination Number
must be specified for all FXO channels on VoiceGear SkyBridge plugged in as extensions
on the PBX.
Use this Number as Post
Selection
Post selection setting defines a number which VoiceGear SkyBridge will pass to the PBX as
DTMF tones sequence. Post selection setting can be used to forward a call to a specific
extension if your PBX doesn't support “direct inward dialing” but supports DISA or IVR
options.
Every destination route is defined as a combination of trunk name selected from a drop‐down list of all
configured channels and a destination or post selection number. Once you have configured all parameters in this
section click on the “Add” button to add the destination to the list.
Order of destinations defined in this list is important because incoming calls will always be directed to the first
available destination. If there are multiple destinations defined in this list and the first destination is busy, the
call will be automatically directed to the second destination and so on until an available destination is found.
If you are satisfied with your incoming route settings click the “Save” button to add the new route to the
Inbound Call Routing table. To remove an existing call route from the Inbound Call Routing table click on the
“Delete” action button on the right of each call route entry.
Please Note:
Order of routes defined in the call routing table is essential: routes are processed in the order they appear in
the list. You can order existing call routes by dragging and dropping entries up and down in the call routing
table.
Section 5 above mentioned that VoiceGear SkyBridge can run Skype accounts in two modes: shared office line or
a direct personal line. If you wish to have all calls to a particular Skype account forwarded to a specific office
extension (for example, you can use your own Skype account and have all incoming calls to this account
forwarded to your office extension) you can create a new Incoming call route with the following settings:
• Enter “Incoming calls to John’s extension” in the description field of the basic settings section.
• Select your personal Skype account from a list of all Skype accounts running in VoiceGear SkyBridge (you
must have this Skype account registered first using Skype ‐> Accounts menu) in the first part called
“When Receiving Calls to One of the Following Accounts”.
• Select a destination trunk (or leave as “Any trunk”) and enter your office extension number in the “Use
this Number as Destination” field in the second part called “Route Them to the First Available
Destination in the Following List”
• Click “Save” button to create the new incoming call route. From now on, any call incoming to your
personal Skype account will be directed to your office extension.