Yamaha SXV70SJ Supplementary Service Manual - Spec
–98–
29
Clamp the fuel tank breather
hose, CDI unit lead and Y.P.V.S.
lead aligning with the positioning
tape on the main harness.
30
Clamp the CDI unit lead and
speed sensor lead.
31
Speed sensor lead
32
Connecter joint
33
Care should be taken about the
direction of the fuel hose. The
short side of the letter L should
be on the tank side.
34
To the carburetor
35
Pulser hose
36
Compression spring
37
Oil delivery hose
38
To the oil pump
39
Oil hose
40
Frame directly attached clamp
41
Main harness
42
Main harness must be not
caught between the cooling
hose and frame.
43
Clamp the coolant hose and
main harness. Align the position-
ing tape of the main harness with
the white mark of the coolant
hose. Make sure to point the tip
of the clamp to the inner side of
the vehicle.
44
Coolant hose
45
Main harness should be posi-
tioned along with the coolant
hose.
46
Smoothing condenser
47
Fuse coupler
(For model with starter motor)
48
Fuse box
(For model with starter motor)
49
Clamp the tail / brake light lead,
harness and rectifier / regulator
lead.
(For model with reverse)
Clamp the upper part of the cou-
pler.
(For model without reverse)
Clamp the harness and coupler
so that they do not contact with
the rectifier / regulator. Point the
tip of the clamp to the front side
of the vehicle.
CABLE ROUTING