Yamaha SXV70SJ Supplementary Service Manual - Insp
–7–
COOLING SYSTEM/
THROTTLE CABLE FREE PLAY ADJUSTMENT
INSP
ADJ
WARNING
NOTE:
SAdd coolant to the coolant cold level
a
.
SLoosen the bleed bolt
2
.
SDrain the coolant until no more air bubbles ap-
pear.
STighten the bleed bolt
2
.
Bleed bolt:
3.5 Nm (0.35 m
Skg, 2.5 ftSlb)
SInstall the coolant filler cap.
Apply and lock the parking brake. Start the en-
gine and run it at approximately 2,500
X 3,000
r / min until the coolant circulates (approxi-
mately 3
X 5 minutes). The side heat ex-
changers will be warm to the touch.
To avoid severe injury or death:
SMake sure the machine is securely sup-
ported with a suitable stand.
SDo not exceed 3,000 r/min. Drive line dam-
age and excessive V-belt wear could occur,
or the machine could unexpectedly move
forward if the clutch engages.
SOperate the engine only in a well-ventilated
area.
SRemove the coolant filler cap and bleed the
cooling system again, as described above.
No air bubbles
! OK.
SAdd coolant to the specified level.
3. Install:
SRear bumper cover
SSeat
THROTTLE CABLE FREE PLAY
ADJUSTMENT
SBefore adjusting the throttle cable free play,
the engine idle speed should be adjusted.
SAdjust the throttle cable free play while the
cable is in the cable guide.
1. Measure:
SThrottle cable free play
a
Out of specification
! Adjust.
Throttle cable free play:
1.0
X 2.0 mm (0.04 X 0.08 in)