Yamaha SXV70SJ Supplementary Service Manual - Spec
–102–
1
Clamp the main wire harness,
coolant hose and throttle posi-
tion sensor behind the throttle
position sensor coupler. Point
the tip of the clamp to the intake
silencer side.
2
Throttle position sensor
3
Joint connecter
4
Starter cable
5
Throttle cable
6
Pass the oil pump cable through
the outside of the starter cable.
7
Route the CDI magneto lead
coupler and boot along with the
coolant hose.
8
Ignition coil lead coupler
9
T.O.R.S. lead connector
10
Coolant sensor coupler
11
Main harness
Main harness from the starter
relay to the starter motor.
12
Starter motor
(For model with starter motor)
13
Pass the main harness under the
carburetor heater hose.
14
Housing cap
15
Clamp the main harness and the
metal section of the brake hose.
16
Brake hose
17
Battery negative lead
(For model with starter motor)
18
Coolant hose
19
Starter relay lead
(For model with starter motor)
20
Battery positive lead
(For model with starter motor)
Main harness from the starter
relay to the starter motor.
21
Clamp the main harness.
(For model with starter motor)
22
Point the tip of the clamp to the
outside of the vehicle.
23
Cover
24
CDI magneto lead
25
Throttle position sensor lead
CABLE ROUTING