Yamaha SXV70SJ Supplementary Service Manual - Spec
–86–
1
Frame directly attached clamp
2
Coolant temperature sensor
3
Knock sensor coupler
4
Clamp the coolant hose,
T.O.R.S. lead connector, ignition
coil lead and detonation control
system lead.
S Clamp them in front of the igni-
tion coil lead connector and
T.O.R.S. lead connector.
S All leads should not be routed
constrainedly such as having
too sharp bending.
S Pass the ignition coil lead cou-
pler and T.O.R.S. lead connec-
tor under the inner part of the
bending area of the coolant
hose.
S Point the tip of the clamp to the
downward of the vehicle.
S Do not clamp the coolant tem-
perature sensor lead.
5
Ignition coil lead coupler
6
T.O.R.S. lead connector
7
CDI magneto lead coupler and
cover
8
Joint connector
9
Throttle position sensor coupler
10
Pass the starter (choke), throttle
and oil pump cables through the
holder of intake silencer.
11
Clamp the battery band, wire-
harness and harness.
(For model with starter motor)
12
Clamp the side frame reinforce-
ment with the wire harness,
starter relay lead, gear position
switch lead and main harness.
Align the clamp with the position
white tape.
CABLE ROUTING
SPEC
CABLE ROUTING