Yamaha SXV70SJ Supplementary Service Manual - Spec
9-30
SPEC
CABLE ROUTING
1
Wire harness
2
Ensure this is not kink.
3
50 mm (1.97 in)
4
Make sure that the oil tank cap
and oil tank breather hose do not
touch each other.
5
Route the fuel tank breather hose
over the main switch wire
harness.
6
Route the oil tank breather hose
over the main switch wire
harness.
7
Install the tail/brake light lead
behind the instrument panel.
8
When fastening the tail/brake
light lead with the attached
clamp, bend the clamp inward to
fasten it.
9
Fasten the oil tank breather hose,
fuel tank breather hose and wire
harness at the inside of the
instrument panel screw with a
plastic band.
;
Route the tail/brake light lead
between the fuel tank and the
snowmobile body. Make sure that
the fuel tank does not crush the
tail/brake light lead. Then, fasten
the three pieces of adhesive tape
below the fuel tank as shown.
A
Adhesive tapes
B
To the tail/brake light
C
Pass the wire harness and fuel
tank breather hose through the
cable holder.
D
Fuel sender coupler
E
Install the metal clip facing
downward.
F
Insert the fuel tank breather hose
until it can not be inserted further.
G
Oil level switch coupler
H
Fuel delivery hoses
I
Vacuum hose
J
Oil delivery hose