Yamaha SXV70SJ Supplementary Service Manual - Insp
2-32
INSP
ADJ
STEERING SYSTEM/LUBRICATION
A
T
R
.
.
B
3. Adjust:
•
Ski toe-out
Adjustment steps:
•
Loosen the locknuts (tie-rod)
1
.
•
Turn the tie rods
2
in or out until the specified toe-
out is obtained.
•
Tighten the locknuts (tie-rod)
1
.
Locknut (rod end)
1
:
25 Nm (2.5 m · kg, 18 ft · lb)
LOCTITE
®
CAUTION:
After tightening the inside and outside ball joint
locknuts
1
, make sure the tie rod
2
can be
rotated freely through the ball joint travel. If not,
loosen the locknut
1
and re-position the ball joint
so that the tie rod
2
can be rotated freely. Tighten
the locknuts to specification.
Å
Left side
ı
Right side
Ç
Inside
LUBRICATION
Brake lever, throttle lever and throttle cable end
1. Lubricate the brake lever pivot, throttle lever and
the ends of the throttle cables.
Recommended lubricant:
ESSO Beacon 325 Grease
WARNING
Apply a dab of grease onto only the end of the
cables.
Do not grease the throttle cables.
They could freeze and cause a loss of control.
SCH2720
SCH2725
C
SCH2730
SCH2735