Yamaha SXV70SJ Supplementary Service Manual - Spec
–90–
1
Frame directly attached clamp
2
Clamp so that the oil tank cap
and oil tank breather hose do not
interfere with each other.
Band them beside the instru-
ment panel attaching bolt.
3
Lay the fuel tank breather hose
along the steering gate.
4
Lay the oil tank breather hose
along the steering gate.
5
Tail / brake light lead should not
interfere with the frame edge.
6
Hide the tail / brake light lead
coupler in the inner panel.
Route the tail / brake light lead in
front of the frame clamp.
7
Frame clamp
8
Pass the tail / brake light lead
through the inner side of the
clamp.
9
Make sure to pass the tail / brake
light lead so that it cannot be
caught between the fuel tank
and panel. Secure it to the
groove section of the fuel tank’s
bottom face with an adhesive
tape at 3 places.
10
50 mm (1.97 in)
11
To tail / brake light unit
12
Adhesive tape
13
Pass the fuel tank breather hose
through holder.
14
Fuel sender coupler
15
Body ground lead
16
Attach the clip with its pawl di-
rected downward.
17
Install the fuel tank breather
hose to the end.
18
Compression spring
CABLE ROUTING