Yamaha SXV70SJ Supplementary Service Manual - Powr
POWR
TR
4-24
DRIVE CHAIN HOUSING
INSTALLATION
1. During installation, pay attention to the following.
Å
Properly install the rubber seal onto the drive chain
housing, making sure that there are no gaps.
ı
Make sure that the bearing seals face towards the
drive chain as shown.
C
1
C
2
Be sure to install the spacers in their original
positions, otherwise the brake disc and jackshaft
will stick.
Î
0.1 ~ 0.5 mm (0.004 ~ 0.020 in)
: ESSO beacon 325 grease or Aeroshell grease
#7A
For the jackshaft and drive chain housing installation,
refer to “JACKSHAFT”.
2. Install:
•
Lever rod
1
3. Adjust:
•
Lever rod length
a
Adjustment steps:
•
Loosen the locknuts
2
.
•
Turn the lever rod
1
in or out until the specified
length is obtained.
Lever rod length
a
:
139 ~ 141 mm (5.42 ~ 5.55 in)
•
Tighten the locknuts.
SCH4500
SCH4510