3xLogic VX-2A-B-IWD (R) User Manual - page 69
VIGIL Software v8.8 User Manual | VISIX V-Series All-in-One Cameras
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
69
EVENT SOURCE (TRIGGERS) TAB – ADDING/MODIFYING EVENT RULE
Steps:
1). Under theEvent Source tab of the Add/Modify Event Rule form, the following event trigger
settings can be configured:
Event Source
(Trigger) Setting
Description
Motion Detection
Enable the rule to trigger based off of Motion Detection. Click the Go to Motion
Detection Configuration to edit motion detection settings.
VCA Source
Enable to rule to trigger based off of a VCA (video analytics) source. (i.e. tripwire,
customer not present, etc…) When this box is checked, an additional form will deploy
allowing the user to pick specific VCA elements as trigger criteria (pictured below).
Figure 7-28: Setup Tab – Event Configuration Menu – Event Rules Settings – Event Source Tab - VCA Source
Settings
Available criteria will vary based on active VCA rules.
A trigger mode can also be chosen. Select Rising Edge to trigger an event at the onset
of a VCA rule being triggered. Select Falling Edge to trigger an event at the conclusion
of an event being triggered (latched). Select Both to trigger an event rule regardless
of the state of a VCA event.
Click Go to VCA Configuration to edit video analytics rule settings.
Face Detection
Enable the rule to trigger based off of facial recognition of a specific person.
Click Go to Face Detection Configuration to edit facial recognition settings.
Network Loss/Detect
Enable the rule to trigger whenever network signal loss is detected.
Click Go to Network Loss Configuration to edit network loss settings.
Network Setting
Changed
Enable this rule to trigger whenever a network setting change is detected.
Storage Error
Enable the rule to trigger whenever a storage error is detected.
Recurrence
Enable the rule to trigger on a reoccurring basis. When selected, the user will be able
to assign a time interval for the reoccurring trigger.
Schedule
Enable the rule to trigger based on a schedule. The event rule will remain active only
during the scheduled times.
Click the Go to Schedule Configuration link to open the Schedule settings and
configure a schedule as needed. The Scheduleevent sourceoption will not be
available until schedule settings have been properly configured.