3xLogic VX-2A-B-IWD (R) User Manual - page 86
VIGIL Software v8.8 User Manual | VISIX V-Series All-in-One Cameras
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
86
WEB SERVER SETTINGS
Steps:
1). Opening the Setup Tab>Network Configurationdrop-down menu and clicking the TCP/IPlink
will open the network TCP/IPsettings page.
Figure 7-47: Setup Tab –Network Configuration Menu – Web Server Settings
2). From the Web Serversettings form, a user may configure the camera’s web server connection
settings. Configurable settings include choosing the hypertext protocol (HTTP or HTTPS),
assigning separate port numbers for each protocol and choosing the Authentication Type
(basic or digest) for the active protocol.
3). Click Apply to save any new changes to the Web Server settings.
NTP SETTINGS
Steps:
1). Opening the Setup Tab>Network Configuration drop-down menu and clicking the NTPlink will
open the network NTP settings page.
Figure 7-48: Setup Tab –Network Configuration Menu – NTP Settings
2). From the NTP settings page, a user may enter NTP server connection info for time
synchronization purposes. Up to four NTP servers can be added.
3). After entering a time server address, click the Test button to confirm a connection between
the camera and the selected NTP Server. If the test fails, confirm you have entered in the
correct address for the NTP Server.
4). Click Apply to save settings changes.