3xLogic VX-2A-B-IWD (R) User Manual - page 95
VIGIL Software v8.8 User Manual | VISIX V-Series All-in-One Cameras
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
95
IP FILTERING SETTINGS
Steps:
1). Opening the Setup Tab>Network Configurationdrop-down menu and clicking the IP Filtering
link will open the networkIP Filteringsettings page.
Figure 7-59: Setup Tab –Network Configuration Menu – IP Filtering Settings
NOTE:
IP Filtering is a simple process which essentially decides which types of IP datagrams will be processed
using normal procedures and which will be discarded/ignored.
2). From the IP Filtering settings page, a user may enable IP filtering and configure the following
related settings.
IP Filtering Setting
Description
Always Allow Ping
Request
If enabled, the camera will accept pings, regardless if the incoming ping is
sent from a device with a filtered IP address.
Allow/Deny
Set the IP Filtering Mode to Allow or Deny. Based on your choice,
addresses in the Filtered IP Addresses list will be denied or allowed.
Add…/Remove
Select the Add… button to add an IP address for filtering. Enter an IP
Address and click OK to save the new address.
To remove an existing address from the filtered list, select the address in
the list and click Remove. You will be prompted to confirm the removal.
Click OK to confirm.
3). Click Apply to save changes to IP Filteringsettings.