Cabletron Systems CSX100 series User Manual - Source
ISDN Router
20
Step 4. Connect the Router to an AC Power
Source
The router comes with a built-in power supply and a standard power cable.
Instructions
1. Check to see that the power switch (0=off, 1=on) on the rear of the
router is set off.
2. Connect the power cable (packaged with the router) to the AC power
connector on the back panel of the router and plug the other end into
an AC outlet.
3. After connecting the power source, turn the switch on. The router
will execute a Power-On-Self-Test (POST) when the unit is powered
on. During this test, channel lights will flicker. After successful
completion of the POST and boot of router software, the lights will
reflect ready status. Check the front panel of the router and you
should see that:
In North America:
•
PWR light is lit green.
•
LINE light is blinking or solid if the correct DNs and SPIDs are
found and accepted.
•
NT-1 light is on indicating physical connectivity on the ISDN line.
If the lights do not reflect the ready state as indicated above, refer to
the section Troubleshooting.
Outside North America:
•
PWR light is lit green.