Cabletron Systems CSX100 series User Manual - page 67

RouterCo

nfiguration

53

⇒

 To seed the routing table, you will enter the TCP/IP Route

Addresses into the table using this window.

This window displays a list of each network IP address with the

corresponding subnet mask, metric, and gateway if needed.

The metric is a number between 1 and 15 that indicates the perceived

cost in reaching the remote network or station.

⇒

 To add a new entry, click Add, enter the IP address, subnet mask

and metric in the small window displayed and click OK.

⇒

 You must enter a default route for one remote router (if the target

router will be placing calls to that remote router).  The default route

is specified as: 0.0.0.0  255.255.255.255  1  (or you may click the

default route button).

Note:  There can be only one default route specified for all the remote

database entries. Defining a default route on the WAN is comparable to

defining a gateway on the LAN.

If you have more than one router, be sure to choose only one router as the

default router and change the configuration of the other routers

accordingly.

Enable Address Translation

⇒

 You will need to check this box if you are connection to an Internet

Service Provider that has assigned you a single IP address.

Refer to Network Address Translation (NAT), page 72, for more details.