Cabletron Systems CSX100 series User Manual - Sample Configuration

RouterCo

nfiguration

61

⇒

 If you change any of the router’s configuration settings, be sure to store

the configuration into FLASH memory and reboot the router.

Once you have rebooted the router, you will need to log in again if you wish

to further change the configuration.

Sample Configuration

In this configuration example of a hypothetical network, a small office

(SOHO) will access a central site (HQ) via an ISDN link.  The small office

also has access to Internet through an Internet Service Provider (ISP).

The small office, SOHO, has IP routing enabled to ISP with a Class C

addressing scheme, and to HQ.

Bandwidth-on-Demand is configured for accessing central site HQ.

The default of one line is configured for calling the ISP (though two different

phone numbers are defined for use).

DHCP server’s IP addresses are used. DHCP will be set up to issue DNS

information to the SOHO LAN.

Network Address Translation (NAT) will be enabled to the ISP, since the ISP

assigned SOHO only one IP address.

The following diagram and Network Information Worksheets show

configuration of router SOHO at the small office.

Note:  Blank Network Information Worksheets in Appendix C are

available to enter information for your own configuration.