Cabletron Systems CSX100 series User Manual - Outbound Bridging

ISDN Router

56

⇒

 Seed the table with the SAP information of the primary logon server

on the remote network. All other SAPs will be learned automatically.

This entry is used for spoofing.

⇒

 You can modify the WAN Network Number by clicking Modify.

Enter the 8-character hexadecimal network number for the WAN

link and click OK.

Note: Only one router needs to define this. The other router will

learn this.

Step 5. General Bridging and Routing Controls

⇒

 To set bridging and routing controls and enable an Internet Firewall,

click Bridging/Routing from the main menu.

Note: You should have already entered a remote router into the Remote

Router Database, if you intend to perform outbound bridging.

Outbound Bridging

If you wish the router to perform outbound bridging, you must select a

remote Default Bridging destination to be used on all dial-out

operations.

⇒

 Click the down arrow by the Select Remote field to display the list

of routers in the Remote Router Database and select the router to be

used for the remote router default bridging destination.

Be sure to enable bridging in the Remote Router Database for this

remote router.

Note:  Inbound/outbound bridging from/to specific remote routers can be

disabled by setting bridging off in the Remote Router Database.

TCP/IP Routing

⇒

 Set TCP/IP Routing to On or Off.

The default is TCP/IP Routing Off.  If TCP/IP Routing is Off, then the

Internet Firewall is forced inactive.