Cabletron Systems CSX100 series User Manual - Enable Rip Options
ISDN Router
74
Since it uses multicast addresses, only devices supporting RIP-2 will
listen to RIP-2 packets.
Note: If your network does not support RIP, then use the RIP OFF option
to turn it off.
Enable RIP Options
It is advisable to only turn RIP options ON when instructed to do so by your
network administrator. Make sure that IP routing is enabled by clicking IP
and IPX Routing from the main menu.
Note: RIP options do not apply to Bridging.
Turn on LAN RIP Settings
RIP-1 Compatible is enabled by default. To enable another RIP option:
⇒
From the Configuration Manager’s main menu, click System
Settings and then Ethernet IP Address. Your current IP Address
and Subnet Mask are displayed.
⇒
Select the appropriate RIP options under LAN RIP Settings.
Turn on WAN Settings
RIP is disabled by default. To enable another RIP option:
⇒
From the Configuration Manager’s main menu, click
RemoteRouters. Select your remote router.
⇒
Click TCP/IP Route Addresses. In the TCP/IP Route Addresses
window, click Advanced.
⇒
Select the appropriate RIP options under WAN RIP Settings.
Caller ID Security
Caller ID is an additional security feature on data calls supported by the
router. It allows you to verify phone numbers of the remote routers when calls
come in to the local router. You configure the phone numbers from which a
specific remote router can call and enable or disable this feature systemwide.
Any calls from other numbers will be rejected.