D-Link DES-3528 - xStack Switch - Stackable User Manual - Imp Entry Settings
xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
trapped by the CPU needs to be forwarded by the software. This setting controls the
forwarding behavior in this situation.
Max Entry
Specifies the maximum number of IP-MAC-Port Binding entries. By default, per port max entry
is 5.
IMP Entry Settings
This table is used to create Static IP MAC Binding Port entries on the switch.
To view this window click, Security > IP-MAC-Port Binding > IMP Entry Settings
Figure 9- 6. IMP Entry Settings window
The following fields can be set or modified:
Parameter Description
IP Address
Enter the IP address to bind to the MAC address set below.
MAC Address
Enter the MAC address to bind to the IP Address set above.
Mode
The user may set the IP-MAC Binding Mode here by using the pull-down menu. The choices
are:
ARP – Choosing this selection will set a normal IP-Mac Binding entry for the IP address and
MAC address entered. If the system is in ARP mode, the arp mode entries and acl mode
entries will be effective. If the system is in the acl mode, only the acl mode entries will be
active.
ACL – Choosing this entry will allow only packets from the source IP-MAC binding entry
created here. All other packets with a different IP address will be discarded by the Switch. This
mode can only be used if the ACL Mode has been enabled in the IMP Global Settings window
as seen previously.
Ports
Specify the switch ports for which to configure this IP-MAC binding entry (IP Address + MAC
Address). Click the All check box to configure this entry for all ports on the Switch.
Click Apply for implement changes, click Find to search for an entry, click Show All for the table to display all entries
and click Delete to remove an entry.
131