D-Link DES-3528 - xStack Switch - Stackable User Manual - System Log Configuration
xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
33
System Log Configuration
This section contains information for configuring various attributes and properties for System Log Configurations,
including System Log Settings and System Log Host.
System Log Settings
This window allows the user to enable or disable the System Log and specify the System Log Save Mode Settings. To
configure the system log settings click Configuration > System Log Configuration > System Log Settings:
Figure 6- 10. System Log Settings window
The following parameters can be set:
Parameter Description
Save Mode
Use this drop-down menu to choose the method that will trigger a log entry. You can choose
between On Demand, Log Trigger, andTime Interval.
Minutes (1-65535)
Enter a time interval, in seconds, for which you would like a log entry to be made.
To add a new entry, enter the appropriate information and click Apply. To save the current Log Settings, click Save
Log Now.
System Log Server
The Switch can send Syslog messages to up to four designated servers using the System Log Server.
To configure the system log settings click Configuration > System Log Configuration > System Log Server:
Figure 6- 11. System Log Server window
The following parameters can be set:
Parameter Description
Server ID
Syslog server settings index (1-4).
Server IP Address
The IP address of the Syslog server.
UDP Port
(514 or 6000-65535)
Type the UDP port number used for sending Syslog messages. The default is 514.
Severity
This drop-down menu allows you to select the level of messages that will be sent. The options
are Warning, Informational, and All.