D-Link DES-3528 - xStack Switch - Stackable User Manual - Firmware Information
xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
41
Firmware Information
The following screen allows the user to view information about current firmware images stored on the Switch.
To access this table, click Configuration > Firmware Information:
Figure 6- 22. Firmware Information window
This window holds the following information:
Parameter
Description
ID
States the image ID number of the firmware in the Switch’s memory. The Switch can store two
firmware images for use. Image ID 1 will be the default boot up firmware for the Switch unless
otherwise configured by the user.
Version
States the firmware version.
Size
States the size of the corresponding firmware, in bytes.
Update Time
States the specific time the firmware version was downloaded to the Switch.
From
States the IP address of the origin of the firmware. There are five ways firmware may be
downloaded to the Switch.
R – If the IP address has this letter attached, it denotes a firmware upgrade through the serial
port RS232.
T - If the IP address has this letter attached to it, it denotes a firmware upgrade through Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Simple Network Management Protocol (SNMP).
W - If the IP address has this letter attached to it, it denotes a firmware upgrade through the
web-based management interface.
SSH – If the IP address has these three letters attached, it denotes a firmware update through
SSH.
SIM – If the IP address has these letters attached, it denotes a firmware upgrade through the
Single IP Management feature.
User
States the user who downloaded the firmware. This field may read “Anonymous” or “Unknown”
for users that are unidentified.
Dual Configuration Settings
The following window is used to configure firmware information set in the Switch. The xStack DES-3528 has the
capability to store two firmware images in its memory.