D-Link DES-3528 - xStack Switch - Stackable User Manual - page 43
xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
27
a 1000BASE-T cable for connection between the Switch port and other device capable of a
gigabit connection. The mastersetting (1000M/Full_M) will allow the port to advertise capabilities
related to duplex, speed and physical layer type. The mastersetting will also determine the
master and slave relationship between the two connected physical layers. This relationship is
necessary for establishing the timing control between the two physical layers. The timing control
is set on a masterphysical layer by a local source. The slavesetting (1000M/Full_S) uses loop
timing, where the timing comes form a data stream received from the master. If one connection
is set for 1000M/Full_M, the other side of the connection must be set for 1000M/Full_S. Any
other configuration will result in a link down status for both ports.
Flow Control
Displays the flow control scheme used for the various port configurations. Ports configured for
full-duplex use 802.3x flow control, half-duplex ports use backpressure flow control, and Auto
ports use an automatic selection of the two. The default is Disabled.
Address
Learning
When Enabled, destination and source MAC addresses are automatically listed in the forwarding
table. The default setting is Enabled.
Medium Type
This applies only to the Combo ports. If configuring the Combo ports this defines the type of
transport medium used. SFP ports should be set at Fiber and the Combo 1000BASE-T ports
should be set at Copper.
Click Apply to implement the new settings on the Switch.