D-Link DES-3528 - xStack Switch - Stackable User Manual - page 191
xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Figure 10- 4. Add Ethernet ACL Profile window
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a
new entry enter the correct information and click Create. To return to the Access Profile List page click Back.
The following parameters can be configured.
Parameter Description
To configure this profile select the Ethernet ACL, and use the drop down menu to choose
between tagged or untagged.
Ethernet ACL
Enter a MAC address mask for the source MAC address.
Source MAC Mask
Enter a MAC address mask for the destination MAC address.
Destination MAC
Mask
Select profile based on Ethernet (MAC Address), IP address, IPv6 or packet content mask.
This will change the menu according to the requirements for the type of profile.
Select ACL Type
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
Select IPv4 to instruct the Switch to examine the IPv4 address in each frame's
header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame’s
header.
Select Packet Content Mask to specify a mask to hide the content of the packet
header.
802.1Q VLAN
Selecting this option instructs the Switch to examine the VLAN identifier of each packet
header and use this as the full or partial criterion for forwarding.
175